Q.Lign T.41 | with Q.Grip clamps

Q.Lign T.41 with floor-mounted support column, turnplates and Q.Grip wheel clamps. Operation via 27″ monitor. For wheel alignment professionals.

Ultimate productivity – vehicle after vehicle

The T-Series builds on the existing Q.Lign platform and focuses entirely on wheel alignment. With Q.Lign T.41, workshops raise the bar even higher and can thus exploit their full service potential.

Measuring at the highest level

Camera beam measures permanently from a height of 2.8 meters
No motor, no winch, no wear and tear
No up, no down, no injuries or damage
No movement, no matter if short or long wheelbases

Everything perfectly in sight

Four wheels, four cameras
Separate camera for the rear axle for more accurate toe values on the front axle
Install anywhere within 1.8 to 3.3 meters of the front axle
Measure and adjust from 0 to 2 meters platform height at any time

Work smarter, not harder

All targets work on any wheel reduces setup times and setup errors
Active MEMS Technology: Constant measurement against gravity for uncompromising accuracy
Caster sweep at floor level without the need for a stool or ladder
Access to clear and easy-to-understand PDF reports from anywhere inside your shop